Lock-blade knives have been dated to the 15th century. In Spain, one early lock-blade design was the Andalusian clasp knife popularly referred to as the navaja.^[16] Opinel knives use a twist lock, consisting of a metal ferrule or barrel ring that is rotated to lock the blade either open or closed. In the late 20th century lock-blade pocketknives were popularized and marketed on a wider scale. Companies such as Buck Knives, Camillus, Case, and Gerber, created a wide range of products with locks of various types. The most popular form, the lockback knife, was popularized by Buck Knives in the 1960s, so much that the eponymous term "buck knife" was used to refer to lockback knives that were not manufactured by Buck.

The lockback's blade locking mechanism is a refinement of the slipjoint design; both use a strong backspring located along the back of the knife. However, the lockback design incorporates a hook or lug on the backspring, which snaps into a corresponding notch on the blade's heel when the blade is fully opened, locking the blade into position.^[17] Closing the blade requires the user to apply pressure to the bar spring located towards the rear of the knife handle to disengage the hook from the notch and thus release the blade.^[18][18] In the case of the framelock, the liner is the handle, itself. The Swiss Army knife product range has adopted dual linerlocks on their 111 mm models. Some models feature additional "positive" locks, which essentially ensure that the blade cannot close accidentally. CRKT has patented an "Auto-LAWKS" device, which features a second sliding switch on the hilt. It can operate as any linerlock knife if so desired, but if the user slides the second control up after opening, it places a wedge between the linerlock and the frame, preventing the lock from disengaging until the second device is disabled.